Shoreline Marine offers a range of bilge pumps designed to effectively and quickly remove water from your boat. These pumps are rated for 800 gallons per hour (GPH) and come with a wiring diagram. This article provides a basic understanding of how to wire a Shoreline Marine bilge pump.
Bilge Pump Components
A bilge pump consists of three components: the pump, the float switch, and the wiring. The pump is the most important component and is available in two types: manual or automatic. The manual pump requires the use of a switch to turn it on or off, while the automatic pump is controlled by a float switch that turns the pump on and off automatically. The float switch is mounted in the bilge and senses the water level; when the water reaches a certain level, the switch activates the pump.
Wiring Basics
In order to wire a Shoreline Marine bilge pump, you will need to have some basic knowledge of electrical wiring. The wiring diagram provided with your pump should provide the necessary information to make the connections. Generally, the wiring will consist of black and red wires, a ground wire, and a battery switch.
Installation
Before you begin wiring your Shoreline Marine bilge pump, you should clean and inspect the system. This includes making sure that all connections are clean and tight. Once you have verified that the system is in good condition, you can begin wiring.
Safety First
Any electrical wiring should be done by a qualified and experienced electrician, and all safety precautions should be taken. It is important to turn off the power to the system before beginning any work. This includes disconnecting the battery. Once the power is off, you can begin wiring the components according to the wiring diagram.
Connections
The wiring diagram will indicate which wires must be connected to the pump, float switch, and the battery switch. Each connection should be matched up to the correct wire. After all the wires have been connected, the wiring should be checked to make sure that there are no loose connections or any other issues.
Testing
Once all the connections have been made, the system should be tested. To do this, you should fill the bilge with water and then turn on the battery switch. The pump should turn on and begin to pump out the water. If the pump is working correctly, you can move on to the next step.
Battery Switch
The battery switch should be connected to the bilge pump and the float switch. This will ensure that the pump turns on and off automatically as the water level rises and falls. The battery switch should also be connected to a fuse to protect the system from short circuits and overloads.
Conclusion
By following the wiring diagram and taking safety precautions, wiring a Shoreline Marine bilge pump is relatively straightforward. Once the wiring is complete, you can then test the system to ensure it is working correctly. Once you have checked all the wiring, you can then enjoy the peace of mind that comes from knowing that your bilge pump is properly wired.